Відео

Why are you talking like thiiiiss?

Would that cause my electrode to melt off my spark plug?

My car is putting the p2138

The most important thing to do in a replacing a wheel bearing is to make sure the axle nut is torqued correctly

I'm not a pro mechanic, but I think that rattle test is not enough. I noticed that my 2010 Subaru Impreza had some oily residue in the intake, cleaned old PCV, it did rattle OK. The when I was in the Subaru dealer decided to get a new one, why not. Compared them side by side: - they both rattle the same - when I blow into one direction, they both can be blown with the same resistance - when I blow into another direction, the new one completely block air flow, but the old one remains half way open. It restricts airflow, but why too much from been fully closed like the new one. So I put the new one on, will see if anything changes.

Honestly this has been s great video for me , i have this code on my 98 Nissan frontier, ive changed my fuel injectors, my mass air flow sensor, my fuel filter and i still have it , it idles ruff and smells rich , it runs fine when driving but it just idles ruff , if tried to adjust my carburetor but if i adjust it to highbit gets stuck and redlines until i back off on the screw .... I cant find the problem yet what should i do now?????

Excellent description and exact description of my vehicles performance

But how can check

That ghetto chirp makes it hard to takeyou seriously. Just saying.

🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥

Been trying to prepare mine. Already repaired it. These were the main issues. The starter, starter relay, the fuel pump being bad, Clogged fuel line, Bad battery, bad alternator, car being left on drive. Bad IBS(intelligent battery sensor). After fixing all that it finally turned on. Cleared the check engine light to by cleaning my intake and exhaust solenoids.

Good video

What if the car has no dipstick ie electric, Buy a funnel okay thanks

Thanks

I have a 2010 Tahoe cI have power on both the negative and the power sides to the fan wire Anyone no what that could be

Nice.. you gave me a good idea..

3:06 pm. CDT: What is the potential problem if both camshaft and crankshaft position sensors have been replaced on a 2006 Dodge Dakota and it will start and run but the RPMS go up and down while taking off from idling .

Why does NOBODY talks about the bad compressor VALVE that needs to be replaced sometimes since it won’t allow you Air to cool properly even with Gas in it. We need more videos about the VALVE replacement.

Replacing bad fuel pump caused my regulator to go out, it was probably already on its way out. Thanks for the help.

Can please help me i have a audi Q7 2007 3.0 tdi diesel the car is cranking but no starting it only starts when i press gas pedal or i give electricity I opened the throttle body and he doesn’t close it’s opened all the time please help me I don’t know what to do

Oh god, my Regal has all those symptoms 😢

Straight to the point..luv it

“As far back as I remember, I always wanted to be a gangster”

Awesome! Thanks so much!